A mold temperature controller (often called a “mold temp controller” or MTC)https://8ruiyan.com/en/all-organic-heat-carrier-boilers/ is a device that controls the temperature of molds in plastic injection molding. It circulates fluid through channels inside the mold. This keeps the mold at a stable, set temperature.
Why Mold Temperature Matters
Mold temperature directly affects part quality. If the mold is too cold, plastic may solidify too fast. This causes short shots, weak weld lines, and poor surface finish. If the mold is too hot, cycle time increases. Parts may warp or sink. A mold temp controller solves both problems by holding the temperature steady.
How It Works
The system is simple in principle. A pump moves heat transfer fluid through the mold. A heater warms the fluid when needed. A cooling valve removes excess heat. A sensor reads the mold temperature. The controller adjusts heating and cooling to match the setpoint.
Water is the most common fluid. It is cheap and transfers heat well. For higher temperatures, oil is used instead.
Main Types
Water-type controllers work from about 5°C to 160°C. They suit most standard applications.
Oil-type controllers reach up to 350°C. They are used for engineering plastics and high-temperature processes.
Dual-circuit units control two molds or two zones at once.
Key Benefits
- Stable part dimensions
- Better surface appearance
- Shorter and more consistent cycle times
- Less scrap and fewer rejects
- Longer mold life
Choosing the Right Unit
Match the controller to your process. Check the required temperature range first. Then look at pump flow and heating capacity. The mold’s channel design also matters. Good flow through the mold gives even heating.
Maintenance Tips
- Use clean water or oil
- Replace filters regularly
- Check hoses and seals for leaks
- Clean the heat exchanger when performance drops
Pensieri finali
A mold temperature controller is a small but critical part of injection molding. It protects part quality and keeps production stable. Choosing the right unit and maintaining it well pays off quickly.
For further problems about mold temperature controller, please contact our technical team for expert advice.
Whatsapp:86-19106101570
wechat:86-19106101570
email:fob@jsryan.com
Chinese 
Russian 
Indonesian 
German 
French 
Italian 
Spanish 
Portuguese 
Polish 
Czech 
Turkish 
Korean 
Japanese 
Arabic 
Persian 
Dutch 
English